| 08:40.23 | *** join/#openjtag purl (i=ibot@rikers.org) |
| 08:40.23 | *** topic/#openjtag is this is the place to discuss bootloaders and JTAG |
| 08:42.47 | *** join/#openjtag _julian (n=quassel@dslc-082-083-146-046.pools.arcor-ip.net) |
| 09:48.33 | *** join/#openjtag pirho (i=pirho@gateway/gpg-tor/key-0x2CEEC9CB) |
| 10:49.38 | *** join/#openjtag roxfan (n=dunno@84.116-245-81.adsl-dyn.isp.belgacom.be) |
| 11:09.39 | *** join/#openjtag the-moog (n=the-moog@static-195-248-121-199.adsl.hotchilli.net) |
| 11:52.26 | *** join/#openjtag DJ9DJ (i=daniel@unaffiliated/dj9dj) |
| 11:52.28 | DJ9DJ | hi |
| 12:22.39 | DJ9DJ | is anyone familiar with OpenOCD in combination with AT91SAM7A3? |
| 12:23.37 | DJ9DJ | I am using the scripts for AT91SAM7 and programming works fine. The problem is that the device hangs in reset after programming and does not start executing the code |
| 12:24.33 | DJ9DJ | I need to power-cycle the power or to disconnect the parport-wiggler to make the AT91SAM7A3 executing the code |
| 12:25.18 | DJ9DJ | I use the same config files with AT91SAM7S and everything works fine, after programming the device automatically executes the code |
| 12:25.46 | DJ9DJ | can anyone tell me why this is different on a AT91SAM7A3? |
| 14:24.54 | *** join/#openjtag DJ9DJ (n=Deejay@unaffiliated/dj9dj) |
| 14:24.59 | DJ9DJ | re |
| 14:59.44 | *** part/#openjtag DJ9DJ (n=Deejay@unaffiliated/dj9dj) |
| 15:41.17 | *** join/#openjtag brolin (n=brolin@200.24.16.100) |
| 16:03.52 | *** join/#openjtag dirk2 (n=dirk@p5B0403D8.dip0.t-ipconnect.de) |
| 17:57.08 | *** join/#openjtag gonzo- (n=gonzo@yo.jabber.ru) |
| 18:21.13 | *** join/#openjtag _julian (n=quassel@dslc-082-083-146-046.pools.arcor-ip.net) |
| 19:21.51 | *** join/#openjtag wookey_ (n=wookey@stoneboat.aleph1.co.uk) |
| 19:23.58 | *** join/#openjtag embededman (n=dontboth@113.87.162.10) |
| 23:26.55 | *** join/#openjtag xfiles (n=xfiles@c-98-193-151-150.hsd1.ky.comcast.net) |