| 00:55.47 | *** join/#openjtag ka6sox (n=ka6sox@nslu2-linux/ka6sox) |
| 00:56.02 | *** join/#openjtag dot (n=ka6sox@adsl-66-159-198-116.dslextreme.com) |
| 01:25.57 | *** part/#openjtag bullet (n=bullet@226.54.203.62.cust.bluewin.ch) |
| 03:44.49 | *** join/#openjtag vmaster (i=vmaster@p549B6A4F.dip.t-dialin.net) |
| 07:24.29 | *** join/#openjtag ep1220 (n=NN@gate.epatec.at) |
| 12:23.53 | *** join/#openjtag [g2] (n=g2@nslu2-linux/g2) |
| 13:18.37 | vmaster | anyone with ee knowledge available who could have a look at my jtag controller design? i'm trying to model a tri-state bus, but the simulation tells me that the bus is always high-impedance, no matter what i specify in the simulation |
| 13:32.59 | *** join/#openjtag ep1220 (n=NN@gate.epatec.at) |
| 13:34.14 | [g2] | vmaster I'm not an ee |
| 13:34.21 | [g2] | just a firmware guy |
| 13:34.24 | [g2] | hey ep1220 |
| 13:34.34 | ep1220 | hi [g2] |
| 13:37.00 | vmaster | [g2]: http://mmd.ath.cx/top_level.pdf - that's the top-level schematic - do you know if the bi-directional bus is modeled correctly? |
| 14:18.10 | vmaster | hmmm, looks like it works using modelsim, but not using the ise simulator... |
| 14:21.05 | [g2] | ep1220 how's that hw coming ? |
| 14:21.55 | ep1220 | [g2] i have the schematic finished. |
| 14:22.21 | ep1220 | hope to discuss it with ka6sox before i have the PCBs manufactured |
| 14:22.52 | [g2] | when will you have proto's ? |
| 14:24.12 | ep1220 | depends on what we decide to pay |
| 14:24.27 | ep1220 | standard service is 1 week |
| 14:24.34 | ep1220 | faster costs more |
| 14:24.47 | [g2] | it always does ? |
| 14:24.51 | [g2] | it always does ! |
| 14:25.27 | [g2] | so is this the full board or one that accepts the dip |
| 14:25.39 | ep1220 | dip |
| 14:25.49 | ep1220 | the FTDI is 0.5mm pitch |
| 14:26.20 | [g2] | so dip + board + personality adapter + sw = Full JTAG ? |
| 14:26.51 | ep1220 | dip + board +Sw is full JTAG with ARM 20pin header |
| 14:27.16 | ep1220 | other pinouts need a personality adapter |
| 14:28.26 | [g2] | I'll need the 14 pin special |
| 14:29.38 | ep1220 | Maybe You can mail me the pinout ? |
| 14:30.32 | ep1220 | special adapters can be made relative cheaply |
| 14:33.05 | vmaster | http://www.arm.com/support/Embedded-ICE%20Adaptor%20Schematic.pdf |
| 14:33.16 | vmaster | that's the arm standard 14-pin |
| 14:36.31 | *** join/#openjtag bullet (n=bullet@67.51.77.83.cust.bluewin.ch) |
| 14:42.30 | [g2] | ep1220 absolutely I can e-mail you the pinout :) |
| 14:43.02 | ep1220 | pls do so |
| 14:43.27 | [g2] | vmaster yes but 2 pins are used for rx/tx on serial |
| 14:43.33 | vmaster | ah, ok |
| 14:43.42 | [g2] | ep1220 in the next couple days I will |
| 14:43.50 | ep1220 | k |
| 14:43.57 | [g2] | I'll have to check tomorrow (Monday) which pins |
| 15:18.36 | *** join/#openjtag bullet (n=bullet@67.51.77.83.cust.bluewin.ch) |
| 16:50.46 | *** join/#openjtag bullet (n=bullet@67.51.77.83.cust.bluewin.ch) [NETSPLIT VICTIM] |
| 16:56.50 | *** join/#openjtag bullet (n=bullet@67.51.77.83.cust.bluewin.ch) |
| 18:22.09 | *** join/#openjtag ka6sox (n=ka6sox@nslu2-linux/ka6sox) [NETSPLIT VICTIM] |
| 18:22.09 | *** join/#openjtag nslu2-log (n=nslu2-lo@nslu2-linux/dyoung) [NETSPLIT VICTIM] |
| 18:22.09 | *** join/#openjtag DaKa (n=david@nslu2-linux/daka) [NETSPLIT VICTIM] |
| 18:22.09 | *** join/#openjtag ByronT-Away (n=byron-po@nslu2-linux/ByronT) [NETSPLIT VICTIM] |
| 18:22.10 | *** join/#openjtag NAiL (n=repvik@nslu2-linux/pdpc.active.repvik) [NETSPLIT VICTIM] |
| 18:22.10 | *** join/#openjtag VoodooZ_Log (n=VoodooZ@CPE00c0f021712c-CM000f9fac823a.cpe.net.cable.rogers.com) [NETSPLIT VICTIM] |
| 18:24.38 | *** join/#openjtag ka6sox (n=ka6sox@nslu2-linux/ka6sox) [NETSPLIT VICTIM] |
| 18:24.38 | *** join/#openjtag nslu2-log (n=nslu2-lo@nslu2-linux/dyoung) |
| 18:24.39 | *** join/#openjtag DaKa (n=david@nslu2-linux/daka) |
| 18:24.39 | *** join/#openjtag ByronT-Away (n=byron-po@nslu2-linux/ByronT) |
| 18:24.39 | *** join/#openjtag NAiL (n=repvik@nslu2-linux/pdpc.active.repvik) |
| 18:24.40 | *** join/#openjtag VoodooZ_Log (n=VoodooZ@CPE00c0f021712c-CM000f9fac823a.cpe.net.cable.rogers.com) |
| 21:27.53 | *** join/#openjtag cbpage (n=cpage@ip68-6-39-177.sb.sd.cox.net) |